Iso - Olympus SP·570UZ Instruction Manual

ISO
Changing the ISO sensitivity
AUTO Sensitivity is automatically adjusted according to the conditions of the
subject.
HIGH ISO AUTO
64/100/200/4001
80011600/32001
6400
~ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
This function has a higher sensitivity compared to [AUTO] and
stabilizes the blur caused by a moving subject or camera movement
when taking pictures.
A low value reduces the sensitivity for daylight shooting of sharp, clear
pictures. The higher the value, the greater the camera's light sensitivity
and ability to shoot with a fast shutter speed and in low light conditions.
However, high sensitivity introduces noise into the resulting picture,
which may give it a grainy appearance.
• If set to [6400], [IMAGE SIZE] is limited to [[]M)] and lower.
• If [FINE ZOOM] or [DIGITAL ZOOM] is set to [ON], [6400] cannot be set.
DRIVE
Continuous shooting
Shoots 1 frame at a time when the shutter button is pressed.
- - - - - - -
Focus and exposure are locked at the first frame. The sequential
shooting speed varies depending on the setting of image quality.
H'iillJ
H~
Pictures can be taken at a faster speed than normal sequential
shooting.
Sequential shooting at a speed of approximately 13.5 frames/sec.
• [PRE-CAPTURE] can be set. When set to [ON], pressing the
shutter button halfway stores 10 frames of a picture
immediately before shooting.
PRE-CAPTURE OFF ION
I x5
±0.3 I±O.?I ±1.0
(J)
c
o
~
co
~
<D
0..
o
::J
C
<D
2
BKT
Adjusts the focus 1 frame at a time. The shooting speed is slower
than for normal sequential shooting.
Takes pictures sequentially while changing the exposure for each
frame (Bracket shooting). Focus and white balance are locked at
the first frame.
• When [BKT] is selected, the exposure differential and number
of frames can be set.
Exposure differential
- - - - - -
Number of frames
You can take a sequence of pictures at one time by holding down the shutter button. The camera
will take pictures continuously until you release the shutter button.
Only [0] is available when [IMAGE QUALITY] is set to (RAW] or (RAW+JPEGl
When [H~] or [H~] is selected, other functions are restricted as follows.
• The flash mode is fixed at [®l
• When [H'iillJ] is selected, [IMAGE SIZE] is limited to
~
and lower and the number of pictures
that can be taken continuously to approximately 30 or less (or approximately 20 or less when
[[]M)] and (FitE] are selected). When
[H~]
is selected, [IMAGE SIZE] is limited to
~
and
lower and the number of pictures that can be taken continuously to approximately 30 or less
(including the 10 pictures when [PRE-CAPTURE] is set to [ON]).
• [ISO] settings will be restricted.
40
EN