System Commands & Functions - Bosch Security System User Manual

System Commands & Functions
Below is a summary of the commands covered in this guide. Some of these functions might not be available in your system. If you
attempt to enter a function that's not available, COMMAND DISABLED appears in the display for a few moments before the display
returns to idle text. If the function is available in the system but your passcode is not authorized to perform the function, then NOT
AUTHORIZED displays on the Command Center.
Press the COMMAND bar and then the one or two digits shown in the table below to perform the function. When you use a
command to perform a function, the displays in the function list below do not appear at your keypad.
Command
CMD 1
CMD 1 1
CMD 2
CMD 3
CMD 4
CMD 4 0
CMD 4 4
CMD 4 7
CMD 6
CMD 7
CMD 8
CMD 9
Function
MASTER ARM
MASTER ARM INSTANT
PERIMETER INSTANT
PERIMETER DELAY
SILENCE THE TROUBLE SOUNDER &
CLEAR TROUBLE DISPLAYS
VIEW MEMORY
WALK TEST
RESET SENSORS
WATCH MODE
SPECIAL ALERT
PERIMETER PARTIAL
SPECIAL ALERT