Rear Panel Leds; P2000 G3 Sas Msa System Sff And P2000 G3 Sas Msa System Lff - HP P2000 G3 User Manual

Table 14 LEDs — Disk drive combinations
Online/Activity (green) Fault/UID (amber/blue)
Blinking regularly (1 Hz)
Off
1
This Fault/UID state can indicate that the disk is a leftover. The fault may involve metadata on the disk rather than the disk itself.
See the Clearing disk metadata topic in the SMU reference guide or online help.

Rear panel LEDs

P2000 G3 SAS MSA System SFF and P2000 G3 SAS MSA System LFF

Table 15 LEDs — HP P2000 G3 SAS MSA System LFF and SFF rear panel
LED Description
1 Power supply LEDs
2 Host 6Gb SAS Link Status (ports 1-4)
Host 6Gb SAS Link Activity
(ports 1-4)
3 OK to Remove
4 Unit Locator
5 FRU OK
6 Fault/Service Required
7 Network Port Activity
8 Network Port Link Status
Off
Off
1 2
(Typical)
LINK SAS 1 SAS 2 LINK
ACT ACT
CLI
LINK SAS 1 SAS 2 LINK
ACT ACT
CLI
Definition
See
Green — The port is connected and the link is up.
Off — The port is empty or the link is down.
Blinking — Link has I/O activity.
Off — Link is idle.
Off — The controller module is not prepared for removal.
Blue — The controller module is prepared for removal.
Off — Normal operation.
Blinking white — Physically identifies the controller module.
Off — Controller module is not OK.
Blinking green — System is booting.
Green — Controller module is operating normally.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled power-up or a cache flush
or restore error.
Off — The Ethernet link has no I/O activity.
Blinking green — The Ethernet link has I/O activity.
Off — The Network port is not connected or the link is down.
Green — The Network link is up.
Description
CAUTION:
Removing a drive may terminate the current
operation and cause data loss. The drive is
rebuilding.
Either there is no power, the drive is offline, or the
drive is not configured.
3 4 5 6
LINK SAS 3 SAS 4 LINK
ACT ACT
6Gb/s
SERVICE
CACHE
ACT LINK
CLI HOST
LINK SAS 3 SAS 4 LINK
ACT ACT
6Gb/s
SERVICE
CACHE
ACT LINK
CLI HOST
7 8 9
Power supply LEDs on page 63.
HP P2000 G3 SAS MSA System User Guide
Do not remove the drive.
1
-
59