D2700 6Gb drive enclosure
P2000 G3 MSA System controllers support D2700 6Gb drive enclosures. For information about
P2000 G3 MSA System products, visit http://www.hp.com/go/p2000. Select Related products, select
your drive enclosure, select Support > HP Support & Drivers from the right side of the page, select your
product name, and select Manuals.
P2000 6Gb 3.5" 12-drive enclosure
Table 16
LEDs — HP P2000 6Gb rear panel
LED
Description
1
Power supply LEDs
2
Unit Locator
3
OK to Remove
4
Fault/Service Required
5
FRU OK
6
SAS In Port Status
7
SAS Out Port Status
MSA70 3Gb drive enclosure
A P2000 G3 MSA System controller can also be attached to an MSA70 3Gb drive enclosure running
firmware version 2.18 or later. For information about the MSA70 3Gb drive enclosure, including detailed
steps to upgrade the firmware, see the HP StorageWorks 70 Modular Smart Array Enclosure User Guide
located on the MSA2000 G2 Software Support/Documentation CD shipped with your product, or at
http://hp.com/support/manuals.
1
2
3
Definition
See
Off — Normal operation.
Blinking white— Physically identifies the expansion module.
Not implemented.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled powerup or a cache flush
or restore error.
Green — Expansion module is operating normally.
Blinking green — System is booting.
Off — Expansion module is not OK.
Green — Port link is up and connected.
Off — Port is empty or link is down.
Green — Port link is up and connected.
Off — Port is empty or link is down.
0
0
IN
OUT
0
0
IN
OUT
7
4 5
6
Power supply LEDs
on page 63.
HP P2000 G3 SAS MSA System User Guide
1
61