Rear Panel Leds; 2312I G2 And 2324I G2 - HP 2000i User Manual

Table 6 Disk drive LED combinations (continued)
Online/Activity
(green)
Blinking regularly (1 Hz)
Off
1. This Fault/UID state can indicate that the disk is a leftover. The fault may involve metadata on the disk, rather than the disk itself.
See the Clearing disk metadata topic in the reference guide or SMU online help.

Rear panel LEDs

2312i G2 and 2324i G2

LED Description
1 Power supply LEDs
2 Host 1Gb iSCSI Link Status (port 1)
3 Host 1Gb iSCSI Link Activity (port 2)
4 OK to Remove
5 Unit Locator
6 OK
7 Fault/Service Required
8 Network Port Link Status
9 Network Port Activity
Fault/UID (amber/blue)
Off
Off
1
LINK LINK
iSCSI 1 iSCSI 2
ACT ACT
LINK LINK
iSCSI 1 iSCSI 2
ACT ACT
2 3
Definition
See
Off — The port is empty or the link is down.
Green — The port is connected and the link is up.
Off — The link is idle.
Blinking green— The link has I/O activity.
Off — The controller module is not prepared for removal.
Blue — The controller module is prepared for removal.
Off — Normal operation.
Blinking white— Physically identifies the controller module.
Off — Controller module is not OK.
Blinking green — System is booting.
Green — Controller module is operating normally.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled powerup or a cache flush
or restore error.
Off — The Ethernet port is not connected or the link is down.
Green — The Ethernet link is up.
Off — The Ethernet link has no I/O activity.
Blinking green— The Ethernet link has I/O activity.
HP StorageWorks 2000i G2 Modular Smart Array User Guide
Description
CAUTION:
Removing a drive may terminate the current
operation and cause data loss. The drive is
rebuilding.
Either there is no power, the drive is offline, or the
drive is not configured.
4 5 6 7
8 9 : ;
Power supply LEDs on page
Do not remove the drive.
1
w
40.
37