Elation TVL3000-II WW User Instructions page 5

TVL3000-II WW/CW/DW
System Menu.
The TVL3000-II WW & TVL3000-II CW come with an
easy to navigate system menu. This next section will detail the func-
tions of each command in the system menu. Please read the next
section thoroughly!
ADDR -
DMX Address Setting.
1. To set your address, press either the MENU, UP, or DOWN
buttons until "ADDR" is displayed, press ENTER. "1" will now be
displayed and flashing.
2. Press the UP or DOWN buttons to find your desired address.
When you have found your desired DMX address press ENTER,
and connect your DMX Controller.
DIMM -
Dimmer mode.
1. Press the MENU button until "DIMM" is displayed, press
ENTER.
2. Use the UP and DOWN buttons to adjust the intensity until
you reach your desired intensity. Once you have found your
desired intensity, press ENTER to confirm, then press and hold
the MENU button for at least 3 seconds to activate.
BLND -
Blackout or Stand by mode.
1. Press the MENU button until "BLND" is displayed, press
ENTER. Either Yes or No will be displayed.
2. To activate Blackout press the UP or DOWN buttons until Yes
is displayed, press ENTER to confim. The fixture will now be in
Blackout mode. To deactivate Blackout mode, select No and
press Enter.
©Elation Professionals® - www.elationlighting.com - TVL3000-II WW/CW/DW User Manual Page 9
System Menu TVL3000-II WW/CW/DW
TEST
1. Tap the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test program. To exit the self
test mode press either the MENU or ENTER button.
LED -
off after 20 seconds.
1. Press the MENU button until "LED" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display On at all
times, or "OFF" so that the LED display turns off after 20 sec-
onds.
3. Press ENTER to confirm. To make the LED display reappear,
press and button.
DISP -
180º.
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. Press the UP button to select "ON" to reverse the display, or
"OFF" to reverse it back.
3. Press ENTER to confirm.
FHRS
time (in hours) of the unit.
1. Press the MENU button until "FHRS" is displayed, press
ENTER.
2. The display shows the life time of the unit. Press MENU to
©Elation Professionals® - www.elationlighting.com - TVL3000-II WW/CW/DW User Manual Page 10
- This function will run a self test program.
In this submenu you can have the LED display turn
In this submenu your are able to "flip" the display
- In this submenu the display will show the running
System Menu