Cover Removal And Installation - Permobil ROHO AGILITY Max Contour Back Operation Manual

Cover Removal and Installation

Warnings:
- DO NOT remove or install the AGILITY cover while the individual is in the wheelchair.
- DO NOT use an AGILITY without the cover, foam pad, and, if applicable, the air insert or foam insert.
- Inspect the cover for damage and replace if necessary.
To Remove the Cover
1. On the wide end of the shell:
Pull down to release the cover
flap.
To Install the Cover
1. On the back side of the shell, push the tab, but
not the handle, through the slot at the narrow end.
Press to attach the tab to the shell. Lift the cover
over the narrow end of the shell.
To Remove the Foam Pad, Air Inserts or Foam Inserts From the Cover
1. Unzip the cover.
2. Remove the foam pad from inside the cover with the inserts still attached.
3. Detach the inserts from the fastener strip in the cutout areas of the foam pad.
4. For air inserts: Pull the valve hose back through the holes in the foam pad.
ROHO AGILITY Max Contour Back Support Operation Manual
2. Pull the cover away from the
shell.
2. Make sure the zipper
faces the shell. Slide the
sides of the back shell
into the side pockets of
the cover. Press to attach
the cover to the front side
of the shell.
3. Lift the cover over the narrow end of the shell. Pull to release the hook fastener strip
on the tab. Pull the tab through the slot.
Note: If the air insert will need to
be adjusted after installing the
AGILITY on the wheelchair, see "
Cover Components Installation" :
"Installing the Cover on the Back
Shell - Valve Hose Placement".
5
3. Pull the wide end of the cover over
the wide edge of the shell. Press
to attach the cover flap to the shell.