Winston Industries PF46C Owner's Manual page 6

11. lid Gasket (pressure fryers only) - Seals between lid and
cookpot to maintain pressure in cookpot (reorder #PS1891).
12. lid Valve - (pressure fryers only) Spring loaded pressure
release valve used to back up main vent system at rear of fryer.
Also releases pressure at end of cook cycle by means of lid
lock.
13. Power Switch - Allows operator to turn electrical power on
and off.
14. Dead weight - (pressure fryers only) Weight in main vent
assembly that determines amount of pressure built up in
cookpot when heating cooking oil with lid down.
15. Vent Block - (PF Models only) Has hole through which steam
passes as controlled by dead weight assembly when fryer is
pressurized.
16. clamshell Basket - (see ACCESSORIES-page 9).
17. Heater coils - Electrical elements that heat cooking oil.
18. Insulation - Surrounds cookpot to help maintain cooking oil
temperature by reducing heat loss.
Diagram for PF Series
6
19. muffler - (PF Models only) Collects condensed steam and
20. cone - Supports basket and directs falling particles from
21. collector Gasket - Seals between collector and cookpot wall
22. collector lifting loop - With basket drain hook, means by
23. Heat Plate - (See ACCESSORIES - page 9).
24. accumulated cracklings - Particles which have fallen off from
25. collector chain Handle - handle for dumping contents of
26. main Vent assembly – (LP Models only) Exhaust tube through
14
15
16
17
18
19
20
21
22
23
24
25
www.winstonindustries.com | 1.800.234.5286
FRYERS
muffles steam vent noise at end of cook cycle.
cooking product into collector. Stirring of cooking oil should
not be attempted below cone after first round of cooking
each day.
to maintain pressure in cookpot. (reorder #PS1892).
which collector can be handled from above and pulled up
through cookpot.
cooking product.
collector.
which excess steam is released into the air.
Diagram for LP series (difference noted)
26