Winston Industries PF46C Owner's Manual page 26

PRoGRammInG
PRocESS 6
Programming Process #6 (PC 6) - 2 temperatures, 2 times
Note: Not all fryers have a Process #6.
StEP 1
First choose the channel you want to program.
2 3 4 5 6
WHEN THE
COMPUTER DISPLAYS
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Note: At any time during programming, time settings can be set to :00 indicating from that point on, the fryer will cook at the last
setting entered until the end of the cycle.
26
7 8
PRESS
BUTTON/ACTION
ENTER
6
ENTER
HEAT SETPOINTS H1 and H2


or
ENTER
TIME SETPOINT T1 and T2
 
or
ENTER
 
or
ENTER
www.winstonindustries.com | 1.800.234.5286
FRYERS
StEP 2
In sequence, press the following buttons to enter
programming mode.


then then then

PROG
NOTE
Indicates Programming mode. Press ENTER to proceed.
Press channel button #6 for selecting process #6.
Press ENTER to proceed.
H1 displays momentarily. Repeat from here for H2.
Use arrow buttons to modify. Hold either button for fast
scrolling. Will display in F or C. 250˚F (121˚C) minimum, 360˚F
(182˚C) maximum.
Press ENTER to proceed.
t1 displays momentarily. Repeat for t2. Remember t1 = total
cook time and time t2 indicates time remaining in the cook
cycle.
Use arrow buttons to modify. Hold either button for fast
scrolling. Display shows MM:SS (minutes:seconds). :00
minimum, 99:55 maximum.
Press ENTER to proceed.
Use arrow button to toggle between Open (O) and Pressure (P).
Controller proceeds to next heat setpoint (repeat starting at
STEP 6). If at final pressure setting, program mode will exit.
then
