Winston Industries PF46C Owner's Manual page 17

DaIlY caRE
lid cleaning Instructions (Pressure Fryers only)
1. Remove lid from fryer and disassemble components as shown below. Remove the retainer from the lid valve before removing the
lid lock and handlebar (the lid lock will help to hold the lid valve while unscrewing the retainer).
!
CAUTION:
Do not submerge the pressure gauge (if supplied) or the pressure relief valve (if supplied) in water. Do
not attempt to remove the pressure gauge from the lid. Do not remove the pressure relief valve from the lid. Do not attempt to
force foreign objects inside the pressure gauge or pressure relief valve.
2. Wash all parts at sink EXCEPT THE LID VALVE, PRESSURE RELIEF VALVE, AND PRESSURE GAUGE and dry with a towel. Wipe outside
of gauge and lid valve with a damp cloth, then wipe dry.
3. Lubricate o-ring with cooking oil and reassemble lid. Tighten retainer hand-tight.
Note: Flat end of spring faces retainer on PF Fryer; large end of spring faces retainer on LP Fryer.
4. Lubricate lid gasket with cooking oil and place on lid in groove.
!
DANGER:
Replace lid on fryer only if fryer is free of any water.
5. When re-assembling lid make sure lip on lid lock is positioned properly into slot of lid valve.
LID LOCK
HANDLEBAR
LID LOCK BLOCK
Need to coNtact us?
www.winstonindustries.com | E-mail customerservice@winstonind.com
Phone 1.800.234.5286 | 1.502.495.5400 | 1.502.495.5458 • Mail 2345 Carton Drive | Louisville, KY 40299 USA
PRESSURE GAUGE
(supplied on some models)
SPRING (LP Model)
LARGE END (LP Model)
RETAINER (LP Model)
FIGURE 25
FRYERS
LID VALVE
O-RING
LID
PRESSURE RELIEF VALVE
(supplied on some models)
LID GASKET
SPRING (PF Model)
FLAT END (PF Model)
RETAINER (PF Model)
17