Table of Contents
Advertisement
3
Starting the Phone
3.1
Starting and Logging On
Depending on the settings in your network and telephony system, the start up
procedure may differ from phone to phone. Check the display on your phone
and read the relevant sections in this chapter to continue with the startup
procedure.
When the phone is connected to the network, your phone automatically initiates
the startup procedure when the power is connected to the phone.
After a power failure the phone restarts automatically.
Note: During power-up, the phone display is black for a little while.
LAN access control
Your phone might require a network authentication to gain access to the
network. You then have to enter a valid user identity and password.
Note: The user identity and password used for the LAN access control are
1. On the main page, tap the Enter User ID field and enter your user identity
2. Tap the Enter password field and enter your password. If you need to
3. Tap the Log on button to continue the startup procedure.
Continued startup procedure
After you have logged on successfully, the display shows the logon progress.
When the self test, has been successfully completed, the phone either logs
on automatically, or prompts you to enter your extension number and PIN or
password.
6/1553-DBC 446 01 Uen D5 2008-09-10
not the same as the extension number and Personal Identification
Number (PIN) or password you use to log on to the telephony system.
Contact the system administrator to obtain a new password or change
an old password.
(typically the extension number).
If you need to edit the input, tap the Erase button.
edit the input, tap the Erase button.
Note: You can enter the password from the keypad on the phone, or from
the soft keyboard in the display.
If your user identity and password are not accepted, an error message is
displayed. Contact your system administrator.
Starting the Phone
19
Advertisement
Table of Contents
