[Remote2 Mode]; [Status]; [Default] - Panasonic PT-DW640EL Operating Instructions Manual

6)
Press qw to switch [GROUP].
f The setting will change among [A] to [Z] each time you press
the button.
7)
Press as to select [RESPONSE(ID GROUP)].
r [RESPONSE(ID ALL)]
[ON]
[OFF]
r [GROUP]
[A] - [Z]
r [RESPONSE(ID GROUP)]
[ON]
[OFF]
Note
f Refer to "<SERIAL IN>/<SERIAL OUT> terminal" ( x page 121).

[REMOTE2 MODE]

You can set the <REMOTE 2 IN> terminal.
1)
Press as to select [REMOTE2 MODE].
2)
Press qw to switch [REMOTE2 MODE].
f The setting will change between [DEFAULT] and [USER] each
time you press the button.
f When [USER] is selected, proceed to Step 3).
r [REMOTE2 MODE]

[DEFAULT]

[USER]

[STATUS]

Displays the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
r Contents to be displayed
[INPUT]
[SIGNAL NAME]
[SIGNAL FREQUENCY]
[PROJECTOR RUNTIME]
[LAMP1]
[LAMP2]
[INTAKE AIR TEMP.]
[OPTICS MODULE TEMP.]
[AROUND LAMP TEMP.]
[PROJECTOR TYPE]
[SERIAL NUMBER]
[LAMP UNIT MODEL NO.]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns the response when the ID setting is ALL.
Does not return the response when the ID setting is ALL.
Controls multiple projectors simultaneously by sending the ID of RS-232C.
Set the group from [A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when the ID setting is GROUP.
Does not return the response when the ID setting is GROUP.
The pin assignment of the <REMOTE 2 IN> terminal is used by the factory default setting of the projector.
( x page 124)
The pin assignment of the <REMOTE 2 IN> terminal is used by the setting changed from the factory default
setting of the projector.
Displays the input terminal currently selected.
Displays the input signal name.
Displays the frequency of the input signal.
Displays the operation times of the projector.
* Displays the hours used of lamp 1.
* Displays the hours used of lamp 2.
Displays the status of the air intake temperature of the projector.
Displays the status of the internal temperature of the projector.
Displays the status of the temperature around the lamps of the projector.
Displays the type of the projector.
Displays the serial number of the projector.
Displays the model no. of the lamp unit.
8)
Press qw to switch [RESPONSE(ID GROUP)].
f The setting will change between [ON] and [OFF] each time you
press the button.
3)
Press the <ENTER> button.
4)
Press as to select any from [PIN2] to [PIN8]
and press qw to switch the setting.
f [PIN1] and [PIN9] cannot be changed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
ENGLISH - 81