[Signal List] Menu; Registering A Signal To The List; Renaming The Registered Data; Deleting The Registered Data - Panasonic PT-DW640EL Operating Instructions Manual

[SIGNAL LIST] menu

Select [SIGNAL LIST] from the main menu.
Refer to "Navigating through the menu" ( x page 51) for the operation of the menu screen.
r Registered signal status
f A name can be set for each sub memory ( x page 87).
f Memory number:

Registering a signal to the list

After a new signal is input and the <MENU> button on the remote control or the control panel is pressed, the registration is completed and the
[MAIN MENU] screen is displayed.
Note
f Up to 96 signals, including sub memories, can be registered to the projector.
f There are 12 pages (eight memories of A through L, with eight memories possible on each page) for memory numbers, and it is registered to
the lowest number that is available. If there is no available memory number it will be overwritten from the oldest signal.
f The names to be registered are automatically determined by the input signals and memory numbers.
f If a menu is being displayed, the new signals will be registered at the instant they are input.

Renaming the registered data

Registered signals can be renamed.
1)
Press asqw to select the signal for which
details are to be displayed.
2)
Press the <ENTER> button.
f The [REGISTERED SIGNAL STATUS] screen is displayed.
f The memory number, input terminal, input signal name,
frequency, synchronization signal, etc., are displayed.
f Press the <MENU> button to return to the [REGISTERED
SIGNAL LIST] screen.
3)
Press the <ENTER> button.
f The [REGISTERED SIGNAL SETUP] screen is displayed.
4)
Press as to select [SIGNAL NAME CHANGE].

Deleting the registered data

Registered signals can be deleted.
1)
Press asqw to select the signal to delete.
2)
Press the <DEFAULT> button.
f The [ENTRY SIGNAL DELETE] screen is displayed.
f To cancel the deletion, press the <MENU> button to return to
the [REGISTERED SIGNAL LIST] screen.
86 - ENGLISH
Chapter 4 Settings — [SIGNAL LIST] menu
5)
Press the <ENTER> button.
f The [SIGNAL NAME CHANGE] screen is displayed.
6)
Press asqw to select the text, and press the
<ENTER> button to enter the text.
7)
After the name is changed, press asqw to
select [OK], and press the <ENTER> button.
f The registration is completed and it will return to the
[REGISTERED SIGNAL SETUP] screen.
f When pressing asqw to select [CANCEL] and pressing
the <ENTER> button, the changed signal name will not be
registered and an automatically registered signal name will be
used.
3)
Press the <ENTER> button.
f The selected signal will be deleted.