Connecting Example: Av Equipment; Connecting Example: Computers - Panasonic PT-DW640EL Operating Instructions Manual

Connecting example: AV equipment

Attention
f Always use one of the following when connecting a VCR.
g A VCR with built-in time base corrector (TBC)
g A time base corrector (TBC) between the projector and the VCR
f If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between the
projector and the VCR.
f Use a commercial HDMI/DVI cable with a ferrite core.
Note
f The <DVI-D IN> terminal can be connected to HDMI- or DVI-D-compliant devices. However, images may not appear or may not be
displayed properly on some devices. ( x page 70)
f Use an HDMI cable that conforms to HDMI standards such as an HDMI High Speed cable. If a cable that does not meet HDMI standards is
used, video may be interrupted or may not be displayed.
f The <HDMI IN> terminal of the projector can be connected to an external device with a DVI-D terminal by using an HDMI/DVI conversion
cable, but some devices may not project the image properly or function properly.
f When the DVI-D signal is input, EDID setting may be required depending on the connected device ( x page 70).
f The projector does not support VIERA Link (HDMI).

Connecting example: Computers

Attention
f When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
f Use a commercial DVI-D cable with a ferrite core.
Note
f Use an HDMI cable that conforms to HDMI standards such as an HDMI High Speed cable. If a cable that does not meet HDMI standards is
used, video may be interrupted or may not be displayed.
38 - ENGLISH
Chapter 2 Getting Started — Connections