Dirt Devil Vacuum Cleaner Owner's Manual page 8

LIGHTBULB REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK
-
UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321 -1 134 or your local auto parts store.
1. Lean cleaner handle back. Insert end of standard (flat head) screwdriver into side slot and pry outward to pop headlight lens out
(Diagram 1).
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place.
WARNING: T
Problem
Cleaner won't run
Cleaner won't pick-up
or low suction.
Performance lndicator
Wheel Is Spinning
Dust escaping from cleaner
Cleaner tools won't pick up.
Performance lndicator
Wheel Is Spinning
Headlight not working
Cleaner is difficult to push
REDUCE RISK OF PERSONAL INJURY
-
UNPLUG CLEANER BEFORE SERVICING
Possible Reasons
1. Power cord not firmly plugged into outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
1. Dirt container not installed correctly.
2. Dirt container full.
3. Clogged filter.
4. Nozzleldirt passage clogged.
5. Clear hose inlet clogged.
6. Brushroll worn.
7. Broken or worn belt.
8. Carpet height setting is incorrect.
9. Clog valve activated.
1. Dirt container full.
2. Dirt container not installed correctly.
3. Hose not installed correctly.
1. Hose clogged.
2. Hose inlet clogged.
3. Dirt container full.
4. Filter clogged.
1. Bulb burnt out.
2. Loose electrical wires.
1. Carpet height setting is incorrect.
Possible Solutions
1. Plug unit in firmly.
2. Check fuse or breaker. Replace fuseheset breaker.
3. Take to service center or call 1-800-321 -1 134.
1. Review dirt container Removal and Replacement-Pg. 6.
2. Empty dirt container-Pg. 6.
3. Remove filter and clean-Pg. 7.
4. Remove base nozzle cover; remove obstruction OR
Remove hose; remove obstruction.
5. Remove hose and clean inlet.
6. Replace brushroll-Pg. 7.
7. Replace belt-Pg. 7.
8. Set carpet height adjustment to appropriate
setting for carpet being cleaned-Pg. 6.
9. Clean filters and clear blockages-Pg. 6.
1. Empty dirt container-Pg. 6.
2. Review dirt container Removal and Replacement-Pg. 6.
3. Review Hose Installation-Pg. 5.
1. Remove hose and tools; remove obstruction-Pg. 5.
2. Remove hose and clean inlet.
3. Empty dirt container-Pg. 6.
4. Clean filter-Pg. 7.
1. Replace bulb-Pg. 8.
2. Call 1-800-321 -1 134 for nearest authorized
Royal" Dealer.
1. Set carpet height adjustment to appropriate
setting for carpet being cleaned-Pg. 6.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE
(1 -800-321 -1 1 34)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal" Dealer. Costs of any transportation to
and from any place of repair are to be paid by the owner. The service parts used in this unit are easily replaced and readily available
from an authorized Royal" Dealer or retailer. Always identify your cleaner by the model number when requesting information or ordering
replacement parts. (The model number appears on the back of the cleaner.)