Dirt Devil Vacuum Cleaner Owner's Manual page 7

Fl LTE R REMOVAL & R EPLACEM E NT
~ n p l u g cleaner before changing filter.
This upright contains two filters: HEPA filter (side of cleaner) and PERMA FILTEW with CleanStreamm Filtration (in dirt container) which combined pre-
vent dust and allergens from escaping the vacuum and re-entering the air.
HEPA FILTER
(external)
-
Part# 3-690320-001 located on side of cleaner.
The HEPA Filter should be replaced annually. Write date of filter replacement on label.
1. Grasp tab located at the top of the HEPA filter cover and pull away from the cleaner (Diagram 1).
2. Grasp HEPA filter Cartridge and pull out (Diagram 2). IMPORTANT: Do NOT clean with water.
3. For HEPA filter replacements call 1-800-321 -1 134 (USA & Canada).
4. To Replace: Lay HEPA filter in cover with gasket facing up. Close the cover by pushing it firmly until it snaps into place (Diagram 3).
NOTE: If filter cover is knocked off, replace by aligning the bottom tabs and snapping into place.
PERMA FILTER@WlTH CLEANSTREAMmFILTRATION
(internal)
-
located i n dirt container.The filter s h o u l d
n o t need t o b e replaced b u t s h o u l d b e cleaned every t i m e t h e d i r t container i s emptied t o maximize perfor-
mance o f t h e vacuum (see page 6: Cleaning t h e PERMA FILTER" w i t h CleanStreamW Filtration).
BELT OR BRUSH REMOVAL & REPLACEMENT
1
BELT STYLE:
4 5
1
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL.
TO REMOVE BELT
Flip cleaner to expose nozzle base. Base should lay flat and face up. To remove nozzle cover, use Phillips
screwdriver to remove the four screws. Arrows (Diagram 1) show location of screws. Flip cleaner back over and lift nozzle cover off.
Slide belt off motor shaft (Diagram 2). Lift and remove brushroll (Diagram 3). Dispose of old belt.
TO REPLACE BELT
1. Place belt on motor shaft, then slip brushroll through belt. Place belt in area of brushroll without bristles (Diagram 4).
2. With belt in place, pull and slide brushroll into nozzle (Diagram 3) making sure that the brushroll end caps are in the correct orienta-
tion (Diagram 3a inset).
IMPORTANT: ROTATE BRUSHROLL MANUALLY TO MAKE SURE BELT IS NOT TWISTED.
3. Reattach nozzle cover. Secure by replacing the screws under the nozzle base.
BELT STORAGE
Stretch belt around hooks on back panel of upright (See page 4, Figure 2 for belt storage location).