Auto Sleep; Administrator Management Code Change - Kyocera TASKalfa 181 Operation Manual

5 Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.

Administrator Management Code Change

You can change the four-digit management code for the administrator of this machine.
Important!
• If you change the management code, be sure to note it. If you should forget the management
code, contact your service representative.
• The management code at the factory default setting is 1800 for the 18 ppm model and 2200
for the 22 ppm model.
1 Display the Machine default screen. (See
page 3-12.)
2 Press the
Change [MGMT Code entry].
3 Press the Enter key.
4
Use the numeric keys to input the new administrator
management code.
5 Press the Enter key.
6 Press the Reset key. The message display returns to the copier basic screen.

Auto Sleep

The machine enters automatically the sleep mode when the preset time elapses without any
operation if this setting is turned On.
Notes
• This setting is displayed only on the inch specification machine.
• You can disable the auto sleep function if this function causes inconvenience. It is
recommended, however, to set a longer time that elapses before the auto sleep function is
activated, before disabling this function.
1
Display the Machine default screen. (See
page 3-12.)
2 Press the
3 Press the Enter key.
4
Press the
key or the key to select PIN #
key or the key to select Auto Sleep.
key or the key to select On or Off.
How to Display the Machine Default Screen
Machine Default :
Date/Time:
Display Contrast
PIN # Change
Management Code Change
# keys
How to Display the Machine Default Screen
Machine Default :
Display Contrast
PIN # Change
Auto Sleep
Auto Sleep :
Off
On
*
System Menu
on
: 08:48
:
1800
on
:
: On
3-23