Quick Setups; Receiver & Transmitter Quick Setup; Fbx Quick Setup - SABINE SWM7000 Operating Manual

Quick Setups

3. QuICk SETuPS
3.1. Receiver & Transmitter Quick Setup
Please read Section Four Transmitter Operation and Section Five Receiver Operation for a complete understanding of how to set up
your Sabine Smart Spectrum True Mobility
Selecting RF Channels: It is best to keep
1
the system's channels close together at
the low or high end of the spectrum, i.e.
channels 1, 2, 3, 4, 5 or channels 65, 66, 67,
68 (31, 32, 33, 34 on SWM6000 series). If
there is another 915 MHz or 2.4 GHz source
in the room, grouping the channels reduces
the chances of an overlap. Do not start by
spreading your channels throughout the full
channel range of the system – you are more
likely to encounter interference this way.
Be sure that all transmitters are off. Position receiver so that the antennas are within visual range of the intended
transmitter locations. Transmitter range is about 100 meters, but structural objects in the transmission path can reduce
that range. For best results, maintain a line-of-sight path between receiver antennas and transmitters (see Section
12). Use the TNC Rear-to-Front kit (SWA700) included with the receiver to move antennas to front if necessary.
See Appendix B for more information on multiple-system connection.
2
Turn the OUTPUT LEVEL of the
receiver and mixer gain to the mini-
mum settings.
3
Connect the output (¼-inch or XLR jack) of your receiver to the
mic or line input of your mixer or amplifier (the receiver output
gain can be adjusted to match the mixer input).
4
1. Turn on the receiver.
2. Tap the Channel Select/Contrast button to edit
a receiver channel. (Not necessary on 1-channel
SW71-R & SW61-R receivers).
3. Turn the RF Channel Selector knob to the de-
sired channel.
NOTE: Dual channel receivers will not allow you to select
the same RF channel for both channels.
NOTE: Front panel RF Signal display will only register Sabine transmitters. It will not show RF interference. Use the RF
Scan function in the software to scan for potential RF interference.
Sabine Smart Spectrum ® Wireless
System.
TM
Mixer Balanced Input
(XLR)
Mixer Unbalanced Input
(TRS)
Transmitter range is 100
meters line-of-sight
Use Sabine's SWASS-EXT
Extension Antenna Kit when
line-of-sight path is not possible
from receiver location.
RF Channel Channel Select/
Selector Contrast button
(selects receiver
channel to edit)
8
Power Switch