SABINE SWM7000 Quick Manual

SWM7000 Receiver & Transmitter Quick Setup
Please read Section Four Transmitter Operation and Section Five Receiver Operation of the operating guide for
a complete understanding of how to set up your Sabine 2.4 GHz Smart Spectrum
4 of this Quick Start Guide for tips on channel selection and maximizing RF performance.
1
RECEIVER & TRANSMITTER CHANNEL SELECTION
It is best to keep the system's channels close together at the low
or high end of the spectrum, i.e. channels 1, 2,3,4,5 or channels 65,
66, 67, 68. If there is another 2.4 GHz source in the room, grouping
the channels reduces the chances of an overlap. Do not start by spread-
ing your channels throughout the 70 channel range of the system --
you are more likely to encounter interference this way. See step 3 for
the controls used to select RF channels.
2 CONNECT RECEIVER
Connect the receiver output (¼-inch or XLR jack) to the
mic or line input of your mixer or amplifier.
Mixer balanced
input (XLR)
Mixer balanced
or unbalanced
input (TRS/TS)
3
POWER ON RECEIVER & SELECT RF CHANNEL
a.
Power ON
4
POWER ON & SET TRANSMITTER
a.
Power ON
Open battery/control door
5
SET INPUT (SW75-T ONLY) / ADJUST PAD or LO CUT SETTINGS
SELECT
DOWN UP
a.
Select Input
SW 75- T BELTPACK
TRANSMITTERS ONLY
b.
2-Ch receivers only:
Press Channel Select/Contrast
button to edit receiver channel
Switch
SELECT
1. Select
b.
PAD function
c.
Select RF channel
SELECT
b.
Select
RF channel function
(if necessary)
2. Select
PAD setting
® ®
True Mobility System. See page
ANTENNA POSITION
Transmitter range is 100
meters line-of-sight
d.
Set Level:
Mic: Less than 0
Line: Less than -15
c.
Select
RF channel
SELECT
Select
c.
LO CUT setting
Adjust PAD if audio extends
into Clipping Zone
1
N C
O UT
C 75 H
UT AT Z