Appendix F: Battery Endurance Tests (Typical); Appendix G: Changing Audix Mic Capsules (Sw70-H) - SABINE SWM7000 Operating Manual

Appendices
Appendix F: Battery Endurance Test (Typical)
NiMH AA Battery (SWAA2, Typical)
Appendix G: Changing Mic Capsules (SW60 and 70-H)
Sabine's Mic SuperModeling™ function requires a baseline characteristic for the capsule in use. Therefore, after changing
capsules, you will need to "tell" the transmitter which capsule is now attached. NOTE: this is only necessary when the capsule
is changed.
1
Open the handheld mic's battery door.
2
While holding down the SELECT button, turn on the mic. Continue to hold the select button for about
3 seconds, then let go.
3
One of the screens at right will appear in the transmitter LCD — showing the currently assigned
capsule.
4
Using the transmitter control up/down buttons, select the capsule you now have attached. Wait a few
seconds until the LCD cycles through the transmitter firmware version numbers and returns to the
default display (channel number).
5
IMPORTANT: In order for the new capsule selection to be saved, you must now edit the RF channel
selection. To do this, press the Select button, then use the up/down buttons to change the RF chan-
nel. Wait a few seconds to allow the transmitter screen to return to the default display. NOTE: you
can return to the original channel by repeating the channel selection process.
Sabine Smart Spectrum ® Wireless
60
Audix OM-3
Audix OM-5
Voice Technologies