Appendix D: Dip Switch Settings - SABINE SWM7000 Operating Manual

Appendices

Appendix D: Dip Switch Settings

(Located on the receiver back panel)
Front Panel Lock Status: LOCK 1 indicates all front panel controls are
locked to prevent intentional tampering, or accidental programming. LOCK
2 indicates a subset of controls are locked, allowing selected others to be
adjusted with software only. Default LOCK 2 setting locks out all functions
except FBX and Program Load. In addition, the LCD contrast control is not
locked in Lock 2.
IMPORTANT: Dip Switches 1, 3, 4, & 8 must
always be in down position! The error message
to the right will display on the receiver if the #1
dip switch is not in the down position.
NOTE 1: LOCK 1 overrides LOCK 2.
NOTE 2: Down is the default position.
NOTE 3: Lock settings are saved with the
Presets.
Networking: The first receiver con-
nected to the PC must have dip switch
#7 set to the down position (default).
All other receivers connected within a
network must have dip switch #7 set to
the up position.
Sabine Smart Spectrum ® Wireless
DIP SWITCH STATUS CHART
# SERIES DESCRIPTION
1 ALL (Always Down)
2 ALL FBX Filter Width
3 aLL (Always Down)
4 Digital Output
ND
only
Clock Source
5 ALL Lock 1
6 ALL Lock 2
7 ND Network Enable
only
8 ALL (Always Down)
58
UP STATUS DOWN STATUS
Error OK
1/5 Octave 1/10 Octave
Error OK
External Word (Default) Internal
Clock Input Clock Source
Lock Unlock
Lock Unlock
Networked No networking,
receivers or 1st receiver in
other than 1st. network.
Error OK