SABINE SW70-H1 - QUICK GUIDE SETUP Quick Manual

SW70-H1 Quick Guide Setup
Microphone Pad Settings
Your new Sabine handheld microphone is designed to accept
a wide range of input levels, from spoken word all the way up
to screaming vocals. In order to accommodate this broad range
of inputs, the microphone has a pad setting. Your mic is now
set to -14 dB, which is the preferred setting for concert vocal
performance.
If you need more output out of the micro-
phone (the receiver LCD
the mic output level) then change the pad
settings as described below.
When any level of attenuation is pro-
grammed, the default screen will illuminate
PAD.
Transmitter PAD Adjustment
1. Use the Transmitter Select button to scroll
through functions until PAD flashes in the
Transmitter LCD.
2. Use the Up or Down buttons to select ei-
ther 0, -6, -14 or -20. Selection is stored
after 3 seconds of inactivity.
3. Check to see if the receiver's Audio Level
Meter stays out of the Clipping Zone.
Transmitter Controls
1 Select Button
2 Up Button
3 Down Button
SABINE
meter shows
AUDIO
1
Suggested PAD Settings
Venue
Speech
Loud speech
& vocal performance
Strong vocal
performance
Very strong vocal
performance
Adjust PAD setting so that Re-
ceiver Audio Level Meter stays
out of the clipping zone (last
segment).
To Open: Unscrew
2
lower portion of micro-
phone. Pull down as
you continue to turn
the housing.
To Close: Turn the
housing and push up
until it meets the
3
threads, then screw on.
PAD
0 dB
-6 dB
-14 dB
-20 dB