Permanent Settings In Programming Mode; Permanent Settings In Programming Mode Inserting And Activating The Filter; Setting The Water Hardness - Jura ENA Micro 1 Instructions For Use Manual

4 Permanent settings in programming mode

The rinse stops automatically. Your ENA is
switched off.
E When the ENA is switched off with the On/
Off button, the machine does not consume
standby energy.
E If no action is performed on the machine for
2 hours, the ENA will automatically switch
off to save energy.
4 Permanent settings in pro-
gramming mode
Inserting and activating the filter
Your ENA no longer has to be descaled if you are
using the CLARIS Blue filter cartridge. If you did not
activate the filter cartridge the first time you used
the machine, you can do this now as follows.
E Perform the 'inserting the filter' operation
without any interruptions. This will ensure
that your ENA always produces its best.
Precondition: Your ENA is ready for use.
T Touch the ; and _ symbols for approxi-
mately 2 seconds.
The ;, _, & and L symbols light up brightly.
! T Touch the Filter symbol for approximately
2 seconds.
The Water Tank symbol M lights up.
T Remove the water tank.
T Open the filter holder.
T Insert the filter cartridge into the water tank,
exerting slight pressure.
T Close the filter holder. It will click into place
audibly.
34
E After two months, the filter will cease to
work. Set the date on the date plate on the
filter holder in the water tank.
T Fill the water tank with fresh, cold water and
reinsert it.
The Coffee Grounds Container symbol ?
lights up.
T Empty the drip tray and coffee grounds
container and reinsert them.
The Filter symbol ! lights up.
! T Touch the Filter symbol to start rinsing of
the filter
The Y, <, > and ! symbols flash. The filter
is rinsed.
Rinsing of the filter stops automatically. The
Coffee Grounds Container symbol ? lights
up.
T Empty the drip tray and coffee grounds
container and reinsert them.
The Y, < and > symbols flash, the
machine heats up. Your ENA is once more
ready for use.

Setting the water hardness

E If you are using the CLARIS Blue filter
cartridge and have activated it, there is no
need to set the water hardness.
The harder the water is, the more frequently the
ENA needs to be descaled. It is therefore important
to set the water hardness accurately.
The following water hardness settings are available:
Water hardness Symbol(s) shown in display
Level 1: 1 symbol illuminated
Y
1 – 15° dH
Level 2: 2 symbols illuminated
Y <
16 – 23° dH
Level 3: 3 symbols illuminated
Y < >
24 – 30° dH