Table of Contents
Advertisement
2-3 Main Memory Configuration
The DDR SDRAM memory system consists of two banks and can support the memory
size up to 1 GB per DIMM. If you only use one bank, it does not matter which one you
use and if you use two or more banks, it does not matter which bank you install first.
To install your DDR Modules please follow these steps:
1. Unlock a DIMM socket by pressing the retaining clips outward. The DDR Modules has
only one notch at the center of module. The DDR module will only fit in the right
position.
2. Insert the DDR Module vertically into the DIMM slot, with the correct alignment. Then
push it in until the golden finger on the memory module is deeply inserted into the
socket.
3. The plastic clip on each side of the DIMM slot will automatically close to hold the DDR
Modules in place.
Chapter 2
7
Advertisement
Table of Contents
