Table of Contents
Advertisement
Chapter 2
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load Optimized Defaults. Type [Y] and
then press [Enter] to continue.
5. Set the system configuration in the Standard CMOS Setup menu.
JP6 / 6A (Enable/Disable USB 0/1, 2/3 Device Wake-Up Jumper)
JP6
USB 0/1
An USB keyboard hot key or an USB mouse click can activate this board. To use this
function, select a hot key of your choice at the USB Resume from S3 option under Wake
Up Events in the BIOS's Power On Management screen. You must also set this jumper's
cap to pins 2-3 to use this function.
CN17 (Blue LED Mode Jumper)
These features work entirely the same as the power indicator LED, both shows the
system's power status. The only difference is that this one is blue while the other is red
LED.
12
JP6A
USB 2/3
Pin
Definition
1-2
Disable (default)
2-3
Enable
Advertisement
Table of Contents
