Aaeon 9LIF5 User Manual page 35

2. V/H SYNC+Blank - The system turns off the vertical and horizontal synchronization
ports, writes blanks to the VGA buffer and the monitor's electron gun turns off. This
function requires a monitor with Green features in order to take advantage of the
power saving function. If you enable this function and do not have a Green monitor,
the result will be the same as if you had selected Blank. This function serves as both a
screen saver and a power saver.
3. DPMS Supported - Select this option if your video card supports the Display Power
Management Signaling (DPMS) standard (i.e., you have a monitor that supports
Green features). Use software supplied by your video subsystem to set video power
management options.
Video off In Suspend
This setting determines when the monitor enters power saving mode if it is set to Yes.
The Power Management function must be enabled to use this function.
Suspend Type
Available options: [Stop Grant] and [Pwr-On Suspend].
MODEM Use IRQ
If your computer has a modem use this function to tell BIOS which IRQ is being
occupied by the modem card. When the system is in Green mode, the modem requires an
IRQ assignment to wake up the system and perform tasks. This assignment is compliant
with the APM 1.2 compliant operating systems.
Suspend Mode
The Power Management function must not be set to disabled to enable this function. If
the system runs in Standby mode and the Suspend timer expires, all devices regulated by
power management will shut off and the CPU speed will be 0 MHz.
HDD Power Down
Shuts down any IDE hard disk drives in the system after a period of inactivity as set in
this user configurable field. This feature does not affect SCSI hard drives.
Soft-Off by PWR-BTTN
When set to Delay 4 Sec., this function allows the power button to put the system in
Suspend, a power saving mode. When set to Instant-Off the Soft-Off by PWR-BTN
function is disabled and the computer turns completely off when the power button is
pressed.
Primary/Secondary IDE 0/1
Available options: [Disabled] and [Enabled].
FDD, COM, LPT Port
Available options: [Disabled] and [Enabled].
Chapter 3
31