Table of Contents
Advertisement
3. UART Mode Select
This function allows you to select an operating mode for the second serial port. (Normal
RS-232C serial port / IRDA / SCR / ASKIR 0.57-MB/sec infrared port)
4. UR2 Duplex Mode
Available options: [Half] and [Full].
5. Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical parallel
port.
6. Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select SPP unless you
are certain your hardware and software support one of the other available modes.
7. ECP Mode Use DMA
This item automatically specifies a DMA channel 1 or 3 for the parallel port when it is
set to [EPP] or [ECP+EPP] mode.
8. Game Port Address
This item disables or assigns the address of the Game port. Available options are
[Disable], [201] and [209].
9. Midi Port Address
This item disables or assigns the address of the Midi port. Available options are
[Disable], [300] and [330].
10. Midi Port IRQ
This item specifies an IRQ for the Midi port. Available options are [5] and [10].
USB Controller/USB 2.0 Controller
Enable the on-board Universal Serial Bus (USB V1.1) controller if you want to connect
an USB device to your system. Note that if this setting is disabled, you can still
temporarily use a USB keyboard during boot up so that you can enter BIOS and enable
this setting. If you pass the boot up stage without enabling this function, your PS/2
keyboard will no longer work.
USB Keyboard Support
Select Enabled if your system has a USB keyboard installed on the system board. If your
system has no USB keyboard, select Disabled in this field.
Init Display First
This function allows users to choose AGP or PCI slot to initialize display.
Chapter 3
29
Advertisement
Table of Contents
