SECTION 7—SEAT AND ARMS
Adjusting the Arm Width
NOTE: For this procedure, refer to FIGURE 7.4.
NOTE: When installing the arms during set up, the four mounting screws are installed on the seat
hinge for shipping purposes.
1. Loosen the knob securing the arm tube to the seat frame.
2. Push the arm in or out to the desired position.
Arm
Arm Tube
Seat Frame
Replacing Armrest Pads
NOTE: For this procedure, refer to
FIGURE 7.5.
1. Remove the one mounting screw that
secure the armrest pad to arm.
2. Remove the old armrest pad.
3. Install new armrest pad and securely
tighten with existing mounting screw.
4. If necessary, repeat STEPS 1‐3 to
replace the other armrest pad.
Lynx™L-3X
Knob
FIGURE 7.4 Adjusting the Arm Width
Arm Pad
Mounting Screw
FIGURE 7.5 Replacing Armrest Pads
30
Arm
Arm Tube
Knob
Arm
Part No. 1145807