Invacare Lynx L-3X Owner's Operator And Maintenance Manual page 36

SECTION 10—BATTERIES
3. If necessary, connect the battery cable. Refer to Connecting/Disconnecting the Battery
Cables on page 37.
4. Remove the seat. Refer to Removing/Installing the Seat on page 27.
5. Lifting up to release the hook and loop strips, remove the rear shroud from the scooter.
6. Perform the following to install a battery from the battery tray:
A. With the battery terminals facing towards the center of the scooter, position the
battery onto the battery tray.
B. Position the hook and loop fastening battery strap around the battery and to secure
the battery to the battery tray.
7. Repeat STEP 6 to install the remaining battery into the battery tray.
8. Connect the two GRAY battery connectors to the wiring harness connectors.
9. Align tabs on the rear shroud with the slots (not shown in figure) in the front shroud.
10. Place rear shroud on the frame and press down slightly.
11. Reinstall the seat. Refer to Removing/Installing the Seat on page 27.
NOTE: New batteries MUST be fully charged before using, otherwise the life of the batteries will
be reduced.
Battery Wiring Harness Connectors
Lynx™L-3X
Battery
Connectors
FIGURE 10.2 Removing/Installing the Batteries
Batteries
36
Strap
Part No. 1145807