Pin Assignments And Wiring - Extron electronics DTP HDMI 301 User Manual

Pin Assignments and Wiring

HDMI connector
Figure 5 defines the pinout for the HDMI connector.
Pin Signal
1 TMDS data 2+
2 TMDS data 2
3 TMDS data 2-
4 TMDS data 1+
5 TMDS data 1
TMDS data 1-
6
Figure 5.
To securely fasten an HDMI cable to a device:
1.
Plug the HDMI cable into the panel connection (see figure 6).
3
1
Figure 6.
2.
Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it. The screw does not have to be removed.
3.
Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
CAUTION: Do not overtighten the HDMI connector mounting screw. The shield it
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown.
5.
While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length.
19 1
18 2
HDMI
Type A Receptacle
Pin Signal
7 TMDS data 0–
8 TMDS data 0
shield shield
9 TMDS data 0-
10 TMDS clock+
11 TMDS clock
shield shield
12 TMDS clock-
HDMI Connector
2
Installing the LockIt Lacing Bracket
fastens to is very thin and can easily be stripped.
1 19
2 18
HDMI
Type A Plug
Pin Signal
13 CEC control
14 Reserved
(NC)
15 SCL
16 SDA
17 DDC / CEC
Ground
18 +5 V power
19 Hot plug detect
3
4
5
DTP HDMI 301 • Installation and Operation 7