Table of Contents
Advertisement
Z I P P I E G S
I. ALUMINUM FOOTPLATE
1. Height Adjustment
a) Remove set screws (F) from frame tube.
b) Slide footplate to desired height.
c) The adjustment on each side of the footrest will normally be of equal height.
d) Replace and tighten set screws.
J. 90º FOOTBOARD
1. Height Adjustment
a) Loosen the nuts on the footplate clamp assembly (G).
b) Slide footplate clamps to desired height.
c) Tighten nuts.
2. Angle Adjustment
a) Loosen nuts under the footplate assembly (H) until the adjustable clamp rotates freely
on the supporting tube.
b) Adjust the angle of the footplate.
c) Slide it forward or back for
correct placement.
d) Tighten nuts.
3. Removing Footboard
a) Unscrew the lock knobs (I ) and lift out of clamp assembly.
K. PLATFORM FLIP-UP FOOTPLATE
1. Height Adjustment
See Section B-1.
2. Angle Adjustment
a) Loosen the nuts under the footplate clamp (B) until the adjustable clamp and footplate
rotate freely on the mounting tube.
b) Adjust the angle of the footplate.
c) Tighten nuts.
L. FLIP-UP ARMRESTS
1. Adjustment
Flip-up armrests are height adjustable (3") by moving the armrest assemblies up or down in
the pre-drilled holes on the backrest frame tubes.
a) To adjust armrest upward and downward, loosen cam adjustment bolt (C).
b) Rotate armrest to desired position.
c) Replace and tighten bolt.
M. ADJUSTABLE LOCKING FLIP-UP ARMREST
1. Height Adjustment
a) Remove the hex nuts from the armrest (D) and angle adjustment plate (E) to release
the armrest and plate.
b) Release the bolts from the arm mount (F).
c) Move mount up or down the back post in 1-inch increments for desired height, or
within the arm mount holes for 1/4"inch increments.
d) Replace and tighten nuts and bolts.
2. Angle Adjustment
a) Loosen the hex nut from the angle adjustment plate (E).
b) Tilt the armrest and plate to the desired angle.
c) Tighten nut.
13
11
14
15
16
(Optional)
15
12
F
13
H
G
I
14
B
15
C
16
F
E
D
I X .
930377 Rev. F
Advertisement
Table of Contents
