Footplate Adjustment; Footboard - Sunrise Medical Sopur Argon2 Directions For Use Manual

Footplate Adjustment

Adjusting The Footrest
WARNING!
• Attendant: Do not stand on the footboard! Even if
the user is sitting in the chair, there is still a risk
of tipping over and injury.
• User: When transferring, do not stand on the
footboard, there is a risk of tipping over and
injury.
Releasing the screw (1) will allow you to adjust the
footrest to correspond to the length of your lower leg and
re-attach the footrest. The angle of the footrest may be
individually adjusted by loosening screws (2). The side
protection (3) on the footrest prevents the feet slipping off
accidentally. Make sure that after any adjustment work, all
screws are tightened correctly (see the page on torque)
(Fig. 4.8 - 4.9).
Fig. 4.8
1
36
Fig. 4.9
3
2

Footboard

Footrest - Aluminium
There are several footboards
available.
These can be flipped up to
make it easier to transfer to/
from the chair, (Fig.4.11).
Angle-Adjustable Footboard
The footboard can be flipped up to make it easier to
transfer to and from the chair, (Fig.4.12-4.14).
It can be adjusted to alter the angle to the ground.
Tighten screw (1) on the outside. By loosening the clips
(2) the footboard can be moved to three positions both
forwards and backwards. By adjusting the set screw (3)
the footboard can be changed to a horizontal position. To
do this, the footboard must be flipped up. Make sure that
after any adjustment work, all screws are tightened
correctly (see the page on torque). Ensure that you
maintain the minimum gap to the floor of 2.5 cm
(Fig.4.15).
Footrest - Plastic
Footplates:
The footplates can be flipped up to make it easier to
transfer to/from the chair.
Fig. 4.12
1
Fig.4.14
3
Fig. 4.11
1
Fig. 4.13
2
Fig.4.15
>2.5cm
Argon Rev.C
2