Table of Contents
Advertisement
Z I P P I E G S
N.LENGTH-ADJUSTABLE LOCKING FLIP-UP ARMREST
17
18
(Optional)
1. Height Adjustment
a) Remove the hex nuts from the armrest (A) and angle adjustment plate (B) to release
the armrest and plate.
b) Release the bolts from the arm
mount (C).
c) Move mount up or down the back post in 1-inch increments for desired height, or
within the arm mount holes for 1/4-inch increments.
d) Replace and tighten nuts and bolts.
2. Angle Adjustment
a) Loosen the hex nut from the angle adjustment plate.
b) Tilt the armrest and plate to the desired angle.
c) Tighten nut.
3. Length Adjustment (D)
a) Loosen set screw on underside of adjustable armrest.
b) Set armrest to desired length.
c) Tighten set screw.
NOTE:
Do not set length of armrest longer than frame depth.
O.HEIGHT-ADJUSTABLE ARMRESTS
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate release lever to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad until upper armpost locks firmly into place.
3. Removing Armrest
a. Rotate release lever to first stop and remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked position against armpost.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the bolts on the sides of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a) Loosen the four bolts on the side of the receiver.
b) With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws are installed in the outer armpost.
b) Turn the set screws in or out until the desired fit is achieved.
930377 Rev. F
18
(Optional)
19
19a
6
16
17
C
B
A
18
D
4
19
2
5
1
3
9
7
7
1. Outer armpost
2. Release Lever–
Height
9
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
8. Clamp
9. Receiver adjustment
hardware
I X .
19a
8
Advertisement
Table of Contents
