Beta RR4T USA 400 User Manual page 10

4 - AUTOMATIC TRIP FUNCTION (TD)
T≥ 3" resets LAP and TD
T<3" cycles through functions
This function is always accompanied by the TD caption. The information displayed
represents the total distance covered by the vehicle in kilometres or miles (according to
the selected unit). It is an automatic counter which is activated by the first pulse
generated by the speed sensor.
The counter for this parameter can be reset while in TD mode by pressing the button
for about 3 seconds until 000.0 is displayed. The TD function can be reset while the
vehicle is stationary or in motion and also causes the reset of the LAP parameter.
5 - COUNTDOWN TRIP FUNCTION (Countdown)
T≥ 3" and Vel=0 enables setting of countdown
T<3" or Vel>0 cycles through functions
This function is always accompanied by a flashing TD caption. The counter is always
active and is automatically decreased by 0.1 kilometres or miles according to the
selected unit. The value for this parameter can be changed in TD decrease mode by
pressing the button for about 3 seconds while the vehicle is stationary.
The different figures that make up the counter can be altered starting from the most
significant figure and shifting in successive steps to the least significant figure.
Pressing the button for a short time decreases the value by one step; pressing it for a
longer time allows a different parameter to be selected. After setting the least signifi-
cant figure, press the button for about three seconds to go back to the standard
operating mode. If the parameter reaches 000.0, the system automatically sets it to
999.9.
While in the setting menu, if no buttons are pressed for 20 seconds the system will
automatically return to the standard operating mode.
Moving off (Vel > 0) while the setting mode is activated causes the system to automati-
cally return to the standard operating mode
USA
8