Typematic Delay (Msec); Security Option; Apic Mode; Mps Version Control For Os - Advantech PCA-6187VE-00A2 User Manual

BIOS accepts the following input values (characters/second) for type-
matic rate: 6, 8, 10, 12, 15, 20, 24, 30.

3.4.15 Typematic Delay (msec)

Typematic delay is the time interval between the appearance of two con-
secutive characters, when holding down a key. The input values for this
category are: 250, 500, 750, 1000 (msec).

3.4.16 Security Option

Select whether the password is required every time the system boots or
only when you enter setup.
"System"
if the correct password is not entered at the prompt.
"Setup"
the correct password is not entered at the prompt.
Note:

3.4.17 APIC Mode

This setting allows to enable the APIC mode, the choice is "Disabled" or
"Enabled."

3.4.18 MPS Version Control For OS

This reports if an FDD is available for Windows 95. The selections are
"1.1" or "1.4."
3.4.19 OS Select For DRAM > 64MB
Select OS2 only if you are running OS/2 operating system with greater
than 64MB of RAM on the system. Commands are "Non-OS2" or "OS2."

3.5 Advanced Chipset Features

By choosing the "Advanced Chipset Features" option from the "Initial
Setup Screen" menu, the screen below will be displayed. This sample
PCA-6187 User's Manual
The system will not boot, and access to Setup will be denied
The system will boot, but access to Setup will be denied if
To disable security, select "PASSWORD SET-
TING" in the main menu. At this point, you will
be asked to enter a password. Simply press
<Enter> to disable security. When security is
disabled, the system will boot, and you can
enter Setup freely.
32