Mob Mark; Entering The Mob Mark, Setting Mob As Destination - Furuno GP-7000F Operator's Manual

1. OPERATIONAL OVERVIEW
1.7

MOB Mark

1.7.1

Entering the MOB mark, setting MOB as destination

The MOB (Man Overboard) mark functions to mark man overboard position. You can
inscribe this mark from any mode.
Man
overboad
1. Press and hold down the [MOB/WPT] key immediately for about three seconds
when someone falls onboard, to show the display below.
2. Confirm that YES is selected, and then press the [ENTER] knob to set the MOB
position as the destination. (Choose NO to mark position as a waypoint.)
If you select the MOB position as the destination, the MOB ALARM window
appears. Push the [ENTER] knob to erase it and then the following message
appears on the display.
Distance and bearing to the MOB position are shown in the MOB data box when
the cursor is placed on the MOB mark.
1-6
Range, bearing
Current
position
MOB concept
MAN OVER BOARD!
Set (MOB) as destination?
YES
MOB message window
MOB ALARM
MOB function is activated
MOB ALARM window
FIX
33 07. 674N
132 51. 766W
DST
1.14 nm
MOB data box
MOB
mark
MOB
MOB
162.5°M
0.49 nm
NO
MOB
BRG
187 M
MOB information
Distance and range
to MOB position