Entering The Mob Mark; Erasing All Marks - Furuno GP-1610CF Operator's Manual

6.5 Entering the MOB Mark

The MOB mark functions to mark man over-
board position. The range and bearing to the
MOB position are continuously updated on
the display, to help you navigate to the MOB
position.
Entering the MOB mark
1. Press the EVENT MOB key over 3 sec-
onds. The MOB mark appears at own
ship's position along with a flag. The
MOB position is automatically selected
as destination and the range and bearing
from own ship to the MOB position are
displayed.
Saved MOB position !!
32˚ 59.660'N
130˚ 00.066'E
Begin navigation
to the MOB waypoint
Are you sure?
ENT: Yes ESC: No
Figure 6-4 MOB position display
2. Press the MENU key. (If an autopilot is
connected press the ENT key.)
Range, bearing
Current
Man
position
overboad
Bearing and range
to MOB position
Figure 6-5 MOB concept
To erase the MOB mark, clear the memory
as shown in paragraph 14.9 Clearing the
Memory on page 14-7.
Destination
MOB "flag"
mark
M
00
WP
MOB 120.0 0.8nm
CSE 180.0 SPD 16.8kt 2D
DEP 110m TMP 16.0 C 14:50
POS 34 26.345'N 135 41.232'E
Cancelling MOB position as
destination
1. Press the GOTO key.
SELECT GOTO MODE
WPT List
EVENT List
ROUTE List
Cursor/Route plan
ENT: Sel CLR: Release
Figure 6-6 GOTO selection screen
2. Press the CLR key. You are asked if you
want to cancel MOB position as GOTO.
RELEASE GOTO
ENT: Yes
ESC: No
3. Press the ENT key.
4. Press the MENU key.

6.6 Erasing All Marks

All marks can be erased collectively. Be ab-
solutely sure you want to erase all marks; they
cannot be restored once erased.
1. Press the MENU key.
2. Press the [3] key to select ERASE
TRACK/MARK.
ERASE TRACK/MARK
MARK ERASE
NO
TRACK ERASE
NO
MARK USED
TRACK USED
Figure 6-7 Erase track/mark menu
3. Operate the Cursor Pad to select MARK
ERASE.
ESC: Cancel
YES
YES
0/100 PT
0/2000 PT
6-3