12. Ais Operation; Turning Ais Feature On/Off - Furuno GP-7000F Operator's Manual

12. AIS OPERATION

Connected to an AIS transponder which outputs data in RS-232C format, your plotter
can show the name, position and other nav data of AIS transponder equipped ships.
12.1

Turning AIS Feature On/Off

To activate the AIS feature, do the following.
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose ADVANCED and then press the [ENTER]
knob.
3. Rotate the [ENTER] knob to choose AIS SETUP and then press the [ENTER]
knob to show the AIS menu.
4. Rotate the [ENTER] knob to choose DISPLAY and then push the [ENTER] knob.
5. Rotate the [ENTER] knob to choose On and then push the [ENTER] knob.
6. Rotate the [ENTER] knob to choose ACTIVATION RANGE and then push the
[ENTER] knob.
7. Rotate the [ENTER] knob to set the range from own ship and then press the SAVE
soft key. (Setting range: 0.1 to 50.0 nm)
AIS targets within this range will be monitored.
8. Press the [MENU] key to close the menu.
When turning the AIS feature off, choose Off at step 5.
DISPLAY
ACTIVATION RANGE
CPA ALARM
CPA LIMIT
TCPA ALARM
TCPA LIMIT
AIS menu
On
05.0 nm
Off
00.5 nm
Off
10 min
12-1