Turning The Power On/Off - Furuno GP-7000F Operator's Manual

1.3

Turning the Power On/Off

Turning the power on
Press the [POWER/BRILL] key until you hear a click and a beep. When the unit is
turned on, it proceeds in the sequence shown in the figure below.
GPS PLOTTER SOUNDER
FURUNO ELECTRIC CO., LTD.
Note 1: The example screens shown in this manual may not match the screens you
see on your display. The screen you see depends on your system configuration and
equipment settings.
Note 2: If the message "SYSTEM HAS FAILED START UP TEST. PLEASE CON-
TACT A LOCAL FURUNO REPRESENTATIVE FOR REPAIR. PRESS ANY KEY TO
CONTINUE." appears, contact your dealer for advice.
Note 3: At the very first time you turn on your unit, the simulation mode window ap-
pears. Choose YES or NO as appropriate and push the [ENTER] knob.
The equipment takes 90 seconds to find its position when turned on for the very first
time. Thereafter it takes about 12 seconds to find position each time the power is
turned on. The message "NO FIX", which means the equipment is now finding its po-
sition, appears at the bottom of the plotter display immediately after turning the power
on. When the GPS receiver finds its position, "NO FIX" changes to "2D" or "3D" to
show that position data is now accurate.
Turning the power off
Press and hold the [POWER/BRILL] key until the screen goes blank (about four sec-
onds).
GP-7000F STARTUP TEST
PLOTTER
ROM
RAM
BACKUP DATA
INTERNAL BATTERY : OK
INTERNAL GPS
ECHO SOUNDER
ROM
RAM
POWER SETTING
Start-up sequence
1. OPERATIONAL OVERVIEW
C-MAP electronic charts (ECs) are derived from
: OK
geographical data -including official government
charts - which we believe to be accurate.They are
: OK
neither verified nor approved by Hydrographic
: OK
Authorities. C-MAP ECs are designed only to ease
and speed navigation calculations and so must not
be relied upon as aprimary source of navigation
: OK
information, but rather a backup to the use of
official government charts and prudent navigation
habits.
: OK There is no direct relationship between the color
of water areas and their depth. The navigator shall
: OK
always query the area for depth information and use
: 600 W (or 1 KW) the official paper charts.
In about 30 seconds the
last-used display appears.
You can go to the last-used
display faster by pressing any
key when this screen appears.
WARNING
1-3