Loading The Tool, Fastener Depth Control Adjustment - Bostitch N88WW Operation And Maintenance Manual

LOADING THE N88
EYE PROTECTION which conforms to ANSI specifications and provides protec-
tion against flying particles both from the FRONT and SIDE should ALWAYS be
worn by the operator and others in the work area when loading, operating or ser-
vicing this tool. Eye protection is required to guard against flying fasteners and
debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1-1989 and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide ade-
quate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
N88WW
1. Load nails.
N88RH
1. Open the magazine:
Pull pusher back to
engage the latch.
NOTE: Use only nails recommended for use in Bostitch N88 series nailers or nails
which meet the Bostitch specifications.
3. Allow pusher spring to pull the pusher
forward until it contacts the last nail.
3. Close Magazine:
Release pusher by first pulling back on the
pusher and then pressing the pusher
release tab. Slide pusher against nails.
2. Pull pusher back all the way.
2. Load Nails:
Hold nailer down with
magazine tilted downward.
Insert stick of nails
-6-