Dial-A-Depth™ Fastener Control Adjustment - Bostitch N52FN Operation And Maintenance Manual

Always disconnect air supply: 1. Before making adjustments; 2.
When servicing the tool; 3. When clearing a jam; 4. When tool is
not in use; 5. When moving to a different work area, as accidental
actuation may occur, possibly causing injury.
"DIAL-A-DEPTH
TRIP ADJUSTMENT
NUT
Models N52FN and N62FN, contain a Jam Release feature.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A
JAMMED FASTENER.
2
Jam Clearing
Disconnect air supply from tool.
Relieve fasteners from pusher.
1: Depress latch button
2: With the latch button depressed, rotate latch
assembly upward & forward until latch is on
upward position
6
Full Release Of Magazine
5: Pull latch upward
6: Rotate latch assembly to forward direction
™
" FASTENER CONTROL ADJUSTMENT
The DIAL-A-DEPTH
feature provides close control of the fastener drive
depth; from flush with the work surface to shallow
or deep countersink. First, set the air pressure for
consistent drive in the specific work as described
Shallow
on page 5, then use the DIAL-A-DEPTH
Control adjustment to give the desired depth of
drive.
TO ADJUST DIAL-A DEPTH
CONTROL ADJUSTMENT:
Deep
1
Partial Release Of Magazine
3: Slide magazine to rear of tool
4: Clear Jam
5
Magazine Assembly Removal
7: Slide the magazine assembly to the rear of tool
to disengage
To re-assemble the magazine assembly back on
the tool
Reverse the procedures and re-engage the latch to
lock the magazine assembly in place
-11-
Fastener Control adjustment
™
Fastener
™
TM
FASTENER
JAM RELEASE
3
4