Warranty - LifeSpan Traction II Owner's Manual

Computer not functioning after
connecting power
Motor do not work when you press
START
AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer. In addition, they come with
guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure. Full details of your consumer rights may be found at
www.consumerlaw.gov.au
Please visit our website to view our full warranty terms and conditions:
http://www.lifespanonline.com.au/Warranty-Policy
TRACTION II
1. Please check if the overload protect jump, if it has,
please press it, let it continue operation.
2. Ensure the wires of the power switch, overload
protection, control board and the transformer are
connected correctly.
3. Ensure the wire from the computer to the control board
is connected properly. Remove the upright tube and
check the connection between each wire. Ensure each
wire is completely plugged in; if wires are damaged
please change the wire.
4. Check the state of the transformer is good, if broken,
change it.
1. the motor wire is broken; the safety pipe is broken or
has fallen off;
2. motor wire is not properly connected
3. IGBT on bottom control board is burnt out. Test the
above reasons and change the relevant part.

13. WARRANTY

29