Table of Contents
Advertisement
Repair Procecure:
1. Make sure the base of the gasket is tucked under the lip of the inner liner. DO NOT PULL
UP ON THE INNER LINER.
2. Gently roll the gasket over to expose the edge of the inner liner and locate the dimples
molded into the lip of the inner liner that will be used to locate where the screws will be
installed.
3. Drill 1/8" pilot holes at the dimples.
NOTE: More than one (1) screw may be needed.
CAUTION:Do not let the drill chuck hit the inner panel as it may scratch the inner panel.
CAUTION:Do not over drive the screw as it may crack the plastic inner liner edge.
4. Install the screws supplied in the FIP Door Gasket Repair Kit (Part No. 4318172).
5. Roll the gasket back in place making sure it has a smooth outer edge.
DIMPLES
93
SCREWS
Advertisement
Table of Contents
