Whirlpool MULLION EVAPORATOR DESIGN User Manual page 27

Servicing the Thermostat
The thermostat is mounted in the cross rail area
by two (2) mounting screws.
When removing the thermostat the sensing tube
will also have to be removed. The sensing tube is
routed back to the deffuser. To access the sensing
tube, remove the two (2) screws securing the deffuser cover.
(Fig. 29)
Servicing the Evaporator Fan
Access to the Evaporator Fan is possible once the Evaporator Cover has been removed.
1. Remove the evaporator mounting screws and remove the evaporator cover. (Fig. 30)
2. Remove the four (4) screws securing the fan shroud to the back wall of the freezer section
and lift the shroud off. (Fig. 31)
3. Remove the two (2) screws securing the fan motor mounting bracket to the back wall of the
freezer section and lift the fan motor assembly from its location. (Fig. 31)
4. Disconnect the wiring harness connector from the fan motor terminals.
SHROUD
MOUNTING
SCREW
FAN MOUNTING SCREW
SHROUD MOUNTING
SCREW
Servicing the Bi-Metal
The Bi-Metal (Fig. 32) is attached to the heat shield
on the back wall of the freezer section.
1. Gently pry the bi-metal retaining clip up
and slide the bi-metal out from under the clip.
2. Disconnect the bi-metal wire connector from
the wiring harness plug.
OLD DESIGN
MOUNTING
SCREWS
SHELF STUDS
MOUNTING
SCREWS
Fig. 30
Fig. 31
BIMETAL
21
SENSOR TUBE
THERMOSTAT
Fig. 29
SHROUD
MOUNTING
SCREW
FAN MOUNTING SCREW
SHROUD MOUNTING
SCREW
Fig. 32
12 & 14 cu. ft. Top-Mount