Table of Contents
Advertisement
UNCLIP TO
PULL BRACKET
THERMOSTAT
OUT OF SLOT
GREEN
WIRE
Servicing the Freezer Section
Removing the Freezer Light Assembly
Early Production Models
Some early Production Models of Mid-Line Refrigerators were equipped with a magnetically oper-
ated electronic light switching system. If the unit being serviced does NOT have a rocker switch on
the freezer light assembly, follow these instructions.
Door Magnet - The door magnet may be attached to the door with only an adhesive or it may have
a mounting screw. Replacement door magnets are supplied with a pre-drilled hole and a self-
tapping screw .
1. If the door magnet does not have a mount-
ing screws, pull the magnet away from the
door until the adhesive tape is free of the
door liner. (Fig. 72)
2. If the door magnet has a mounting screw,
remove it and then pull the door magnet from
the door liner as instructed above.
MID-LINE DESIGN
AIR
DAMPER
RED
WIRE
REMOVE
FORM LOOP
HERE
ORANGE
WIRE
SENSOR TUBE FITS INTO SLOT HERE
UNCLIP
BRACKET
Fig. 71
Fig. 72
58
INSET
ADHESIVE
FOAM COVER
THERMAL
WEIGHT
THERMAL
WEIGHT
ACCESS
SLOT
SLOT
DOOR MAGNET
MOUNTING
SCREW
DOOR LINER
16 thru 22 cu. ft. Top-Mount
Advertisement
Table of Contents
