Whirlpool MULLION EVAPORATOR DESIGN User Manual page 48

PHILLIPS
SCREWS
5. Press against the top of the air tower and disengage the two (2) clips from the evaporator
cover. Then, lift the tower and pull it forward to release the four (4) hooks and remove the
tower.
6. Remove the Phillips screw from the access cover and remove the cover.
7. Slide the ground wire clip off the tab of the evaporator cover.
8. Remove the two (2) hex-head screws from the top of the evaporator cover and the two he-
head screws from the fan motor bracket and remove the evaporator cover.
MOUNTING
SCREWS
Servicing the Evaporator Fan Motor
1. Remove the two (2) screws securing the fan motor bracket to the rear wall of the freezer
section. (Fig. 52)
2. Disconnect the three wires from the fan motor terminals ( Fig. 53, INSET ) and remove the
fan motor assembly. (Fig. 53, Inset)
NEW DESIGN
Fig. 51
ACCESS
PANEL
MOUNTING
SCREWS
FAN
SCREW
GROUND
WIRE
SLOTS
Fig. 52
42
PHILLIPS
SCREWS
TABS
MOUNTING
SCREWS
14 cu. ft. Top-Mount