Remove The Air Baffle - HP ProLiant ML350p Gen8 User Manual

WARNING:
adequately stabilized before extending a component from the rack.
WARNING:
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
After performing the installation or maintenance procedure, slide the server back into the rack, and then
3.
press the server firmly into the rack to secure it in place.
WARNING:
latches and sliding the server into the rack. The sliding rails could pinch your fingers.

Remove the air baffle

Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 21).
o
Power down the server (on page 20).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 24).
o
Remove the access panel (on page 23).
5.
To reduce the risk of personal injury or equipment damage, be sure that the rack is
To reduce the risk of personal injury, be careful when pressing the server rail-release
To reduce the risk of personal injury, be careful when pressing the server rail-release
("Remove the tower bezel" on page 21).
Operations 25