Table of Contents
Advertisement
Options:
1.
RWs 12/142
The RWS 12/142 features a rear hub width of 142mm for 12mm through axle which
only matches with the related 142mm rear dropouts in combination with the
12mm DT RWS.
219574 Dropout Set IDS 2 142/RWS 12
2. RWs 12/135
The RWS 12/135 features a rear hub width of 135mm for 12mm through axle which
only matches with the related 135mm rear dropouts in combination with the
12mm DT RWS.
219573 Dropout Set IDS 2 135/RWS 12
3. RWs 5/135
The RWS 5/135 features a rear hub width of 135mm for regular QR axles which only
matches with the related 135mm rear dropouts in combination with the 5mm DT RWS.
219572 Dropout Set IDS 2 135/RWS 5
Beside the complete sets as shown above for a change of the rear hub/axle system
you can also order the right side RD hanger separately via the Scott distribution in
case you need this to repair a damage on the RD hanger.
219575 Dropout Hanger right side IDS 2 135/RWS5
219576 Dropout Hanger right side IDS 2 135/RWS12
219577 Dropout Hanger right side IDS 2 142/RWS12
34
BIKE OWNERS MANUAL
front fork set-up/
chanGe of front fork
For the set up of the front fork please use the fork specific manual attached to the bike.
We recommend using front forks with a travel of 180mm (565mm from mid of axle -
top of crown), as this will not influence the geometry and alter handling of the bike.
important:
No triple clamp forks are allowed on Genius LT!
pivot maintenance
The pivot and bearings on SCOTT Genius LT are extremely easy to maintain.
An external treatment with a grease spray after every bike wash is all you have to do.
We do not recommend heavy grease sprays since these will leave a film on the parts
which is difficult to remove. We recommend the same for the chain also.
If you have to change the bearings you can order them included in a service kit at your
local SCOTT dealer with
219565 Swingarm-Rep. Kit Genius LT
or buy them with international parts number as shown below in a hardware store.
- 4 x 6802 (15x24x5mm)
- 2 x 6803 (17x26x5mm)
- 2 x 61800 (10x19x5mm)
In case of a change of the bearings or of the rear swingarm you should contact your
local SCOTT dealer as you need special tools for disassembly and assembly.
35
scott-sports.com
Advertisement
Table of Contents
