Set-Up Of Other Shock Models; Bb Standards - Scott 2013 Genius LT Owner's Manual

set-up of other shock modeLs

scott strongly recommends using only the scott equalizer 3 shock with the
Genius LT bike, as we designed both parts for a perfect matching combination with
a linear suspension rate.
If you want to use a different rear shock model than the one originally on the bike,
please make sure that the shock will not in any position hit the frame and cause a
damage to the frame.
Please follow the instruction below:
- Please make sure that the rear shock or its accessory parts do not touch the frame
when mounting or suspending.
For doing so release the air/remove the coil, install the shock and extend the shock
completely.
- If the shock touches the frame while doing so, do not use this shock in order to avoid
damage to frame, swing arm or shock.

bb standards

Genius LT with is available with 2 different Bottom Bracket systems.
- The carbon frames are designed for PressFit Cartridges (PF).
PF BB 92 has a housing width of 89.5mm with an inner diameter for the cartridges
of 41mm.
- The alloy frames are designed for 73mm threaded BB Cartridges.
24
BIKE OWNERS MANUAL
front deraiLLeur (fd) mountinG detaiLs
On Genius LT you will find a Shimano E-type front derailleur but fixed directly on the
swingarm without the plate that is fixed normally between the bottom bracket bearing
cup and the bottom bracket housing of the front triangle or a SRAM Direct Mount
Type S3 FD.
Please note that you always need to use the adapter plate attached to the bike or
frame set between chainstay and front derailleur.
This adapter can be ordered at the Scott distribution with parts number:
219566 FD-Mount Plate Set Genius LT 2011 one size
- Similar to Genius design
- Chain plate uses same bolts as Genius
- New adaptor is secured by 2xM5x9mm Allen key bolts
For Genius LT carbon frames: For Genius LT alloy frames:
only for Shimano FD
25
scott-sports.com