Operation; Control Panel - Royal Sovereign RSC-5500H Owner's Manual

OPERATION

CONTROL PANEL

USING fOOT PEDAL
Place the foot pedal on the floor in front of the machine. Once all correct settings are displayed, you may use the foot
pedal to operate the laminator for "Hands Free Operation."
1. To activate the machine, press the foot pedal once and then release. Repeat to stop the rollers.
2. Press the foot pedal and hold to get slow speed mode to put or set the laminating film or medium.
Note: In slow speed mode, the safety laser sensor is inoperative.
Indicate the roller pressure value(according to the
different material and different size to set a
Pressure
reasonable pressure value) from 0~9.
• See page11.
To change the mode from cold to hot or oppositely.
Heat Temperature for hot mode on upper rpller is
max.122˚F 50˚C.
Reverse To reverse the rollers, press and hold the button.
Rotate the knob to control the roller's speed from
Speed 0 to 8.5m/min. (Ensure the speed sensor is
working that something is placed on it. )
Run To start the rollers.
Stop To stop the rollers.
The LED will flash when the beam of the optical
Safety safety device at the input side of the nip is not
interrupted.
8